# model: RouterBOARD LHG 5nD # serial-number: 6D0A0567131F # firmware-type: ar9344L # current-firmware: 3.30 # installed-version: 6.49 # Flags: U - undoable, R - redoable, F - floating-undo # ACTION BY POLICY # U user mentes added admin write # policy # U user group backup added admin write # policy # # software id = DUWZ-8YW8 # # model = RouterBOARD LHG 5nD # serial number = 6D0A0567131F /interface wireless set [ find default-name=wlan1 ] adaptive-noise-immunity=ap-and-client-mode antenna-gain=0 band=5ghz-a/n channel-width=20/40mhz-Ce comment="UPLINK ARPAS" country=uzbekistan disabled=no frequency=5180 frequency-mode=superchannel installation=any mode=station-bridge radio-name=Tet scan-list=5060,5180,5500,5825 ssid=at station-roaming=enabled wireless-protocol=nv2-nstreme wps-mode=disabled /interface bridge add name=bridge1 /interface ethernet set [ find default-name=ether1 ] advertise=10M-half,10M-full,100M-half,100M-full,1000M-half,1000M-full full-duplex=no speed=10Mbps /interface wireless nstreme set wlan1 comment="UPLINK ARPAS" enable-nstreme=yes /interface wireless manual-tx-power-table set wlan1 comment="UPLINK ARPAS" /interface wireless security-profiles set [ find default=yes ] authentication-types=wpa-psk,wpa2-psk eap-methods="" supplicant-identity=MikroTik wpa-pre-shared-key=SZELESTE wpa2-pre-shared-key=SZELESTE /ip ipsec proposal set [ find default=yes ] enc-algorithms=3des /ip pool add name=GW-TET.MAGICNET.HU/PPPOE1 ranges=86.109.76.129-86.109.76.190 add name=TARTOZOK ranges=192.168.251.0/24 /ppp profile set *0 dns-server=86.109.64.5,193.194.159.224 rate-limit=64k use-upnp=no /queue interface set ether1 queue=ethernet-default /routing ospf instance set [ find default=yes ] redistribute-connected=as-type-1 redistribute-static=as-type-1 /snmp community set [ find default=yes ] addresses=86.109.64.0/27 add addresses=86.109.64.14/32 name=partnerlogin /system logging action set 0 memory-lines=500 set 1 disk-lines-per-file=100 set 3 remote=86.109.64.16 /user group add name=backup policy="ssh,read,sensitive,!local,!telnet,!ftp,!reboot,!write,!policy,!test,!winbox,!password,!web,!sniff,!api,!romon,!dude,!tikapp" #error exporting /interface bridge calea /interface bridge port add bridge=bridge1 interface=wlan1 add bridge=bridge1 interface=ether1 /interface bridge settings set use-ip-firewall=yes /ip neighbor discovery-settings set discover-interface-list=!dynamic /ip address add address=10.96.103.7/24 interface=wlan1 network=10.96.103.0 /ip dns set servers=86.109.64.5,86.109.64.66 /ip firewall address-list add address=86.109.64.0/27 list=support add address=10.0.0.0/8 list=support add address=86.109.64.0/19 comment="Ez torolheto" list=support add address=192.168.88.0/24 list=support #error exporting /ip firewall calea /ip firewall filter add action=accept chain=input comment=telnet,ssh,ftp dst-port=21-23 protocol=tcp src-address-list=support add action=drop chain=input comment=telnet,ssh,ftp dst-port=21-23 protocol=tcp add action=accept chain=input comment="Bandwidth test" protocol=tcp src-address-list=support src-port=2000 add action=accept chain=input comment="Bandwidth test" dst-port=2000 protocol=tcp src-address-list=support add action=add-src-to-address-list address-list=Syn_Flooder address-list-timeout=30m chain=input comment="Add Syn Flood IP to the list" connection-limit=30,32 protocol=tcp tcp-flags=syn add action=drop chain=input comment="Drop to syn flood list" src-address-list=Syn_Flooder add action=add-src-to-address-list address-list=Port_Scanner address-list-timeout=1h chain=input comment="Port Scanner Detect" protocol=tcp psd=21,3s,3,1 add action=drop chain=input comment="Drop to port scan list" src-address-list=Port_Scanner add action=jump chain=input comment="Jump for icmp input flow" jump-target=ICMP protocol=icmp add action=add-src-to-address-list address-list=Port_Scanner address-list-timeout=1h chain=input comment="NMAP FIN Stealth scan" protocol=tcp tcp-flags=fin,!syn,!rst,!psh,!ack,!urg add action=add-src-to-address-list address-list=Port_Scanner address-list-timeout=1h chain=input comment="SYN/FIN scan" protocol=tcp tcp-flags=fin,syn add action=add-src-to-address-list address-list=Port_Scanner address-list-timeout=1h chain=input comment="SYN/RST scan" protocol=tcp tcp-flags=syn,rst add action=add-src-to-address-list address-list=Port_Scanner address-list-timeout=1h chain=input comment="FIN/PSH/URG scan" protocol=tcp tcp-flags=fin,psh,urg,!syn,!rst,!ack add action=add-src-to-address-list address-list=Port_Scanner address-list-timeout=1h chain=input comment="ALL/ALL scan" protocol=tcp tcp-flags=fin,syn,rst,psh,ack,urg add action=add-src-to-address-list address-list=Port_Scanner address-list-timeout=1h chain=input comment="NMAP NULL scan" protocol=tcp tcp-flags=!fin,!syn,!rst,!psh,!ack,!urg add action=drop chain=input comment="Block all access to the winbox - except to support list # DO NOT ENABLE THIS RULE BEFORE ADD YOUR SUBNET IN THE SUPPORT ADDRESS LIST" dst-port=8291 protocol=tcp src-address-list=!support add action=accept chain=input comment="Accept to established connections" connection-state=established add action=accept chain=input comment="Accept to related connections" connection-state=related add action=accept chain=input comment="Full access to SUPPORT address list" src-address-list=support add action=accept chain=input dst-address=255.255.255.255 add action=log chain=input comment="Drop anything else! # DO NOT ENABLE THIS RULE BEFORE YOU MAKE SURE ABOUT ALL ACCEPT RULES YOU NEED" disabled=yes add action=drop chain=input comment="Drop anything else! # DO NOT ENABLE THIS RULE BEFORE YOU MAKE SURE ABOUT ALL ACCEPT RULES YOU NEED" add action=accept chain=ICMP comment="Echo request - Avoiding Ping Flood" icmp-options=8:0 limit=10,15 protocol=icmp add action=accept chain=ICMP comment="Echo reply" icmp-options=0:0 protocol=icmp add action=accept chain=ICMP comment="Time Exceeded" icmp-options=11:0 protocol=icmp add action=accept chain=ICMP comment="Destination unreachable" icmp-options=3:0-1 protocol=icmp add action=accept chain=ICMP comment=PMTUD icmp-options=3:4 protocol=icmp add action=drop chain=ICMP comment="Drop to the other ICMPs" protocol=icmp add action=jump chain=output comment="Jump for icmp output" jump-target=ICMP protocol=icmp add action=fasttrack-connection chain=forward connection-state=established,related protocol=tcp add action=accept chain=forward connection-state=established,related protocol=tcp /ip proxy set max-cache-size=none parent-proxy=0.0.0.0 /ip route add distance=1 gateway=10.96.103.1 add distance=200 gateway=86.109.65.1 /ip service set www address=86.109.64.0/27 set api address=86.109.64.0/27 set api-ssl address=86.109.64.0/27 /ip smb shares set [ find default=yes ] directory=/pub /ip ssh set allow-none-crypto=yes forwarding-enabled=remote /ppp aaa set interim-update=5m use-radius=yes /radius incoming set port=1700 /snmp set contact=admin@rlan.hu enabled=yes location=Tet trap-target=0.0.0.0 /system clock set time-zone-autodetect=no time-zone-name=Europe/Budapest /system identity set name=gw-tet-arpas /system logging add disabled=yes topics=wireless add action=remote topics=info add action=remote topics=critical add action=remote topics=error add action=remote topics=warning add action=remote topics=info add action=remote topics=error add action=remote topics=critical add action=remote topics=warning /system ntp client set enabled=yes primary-ntp=86.109.64.5 server-dns-names=time.rlan.hu /system scheduler add interval=6d name=mentes on-event=mentes policy=ftp,reboot,read,write,policy,test,password,sniff,sensitive,romon start-date=aug/28/2018 start-time=09:36:57 /system script add dont-require-permissions=no name=mentes owner=admin policy=ftp,reboot,read,write,policy,test,password,sniff source="/export file=export\r\n/tool e-mail send from=\"backup@rlan.hu\" to=\"backup@rlan.hu\" subject=([/system identity get name] . \" export\") file=export.rsc\r\n/system backup save name=backup\r\n/tool e-mail send from=\"backup@rlan.hu\" to=\"backup@rlan.hu\" subject=([/system identity get name] . \" Backup\") file=backup.backup" /system upgrade upgrade-package-source add address=86.109.64.1 user=root /system watchdog set auto-send-supout=yes ping-start-after-boot=55m send-email-from=gw-tet@magicnet.hu send-email-to=magic@magicnet.hu send-smtp-server=86.109.64.10 watch-address=10.96.103.6 /tool bandwidth-server set max-sessions=10 /tool e-mail set address=86.109.64.10 from=gw-tet-arpas@magicnet.hu /tool graphing interface add /tool graphing resource add